Hallo @ all.
Da ich gerade fest mit meinem projekt am kämpfen bin und den motor jetzt doch neu aufbaue bin ich auf diese hauptlagerkappen gestosen Milodon Main Cap Kits 11160
Hat einer von euch schonmal so einen umbau gemacht?
These aftermarket main bearing caps not only strengthen factory 2-bolt blocks, but they will also add a measurable degree of strength to 4-bolt blocks. They're made from precision-machined, high-strength steel, which has the proper balance of strength and flexibility to allow for the transfer of increased shock loads to the crank and bearings. The secret is in the side bolts. They are angled so that they pull from the side walls of the block and not from the flimsy main web area. They'll also load the cap against the register step, which will prevent dreaded "cap walk." They can be installed by anyone with a hand drill and a tap and they come with the necessary bolts, washers, and drill bushing to complete the installation. These Milodon main cap kits are available in your choice of angled or straight bolts.
Das hört sich mal nicht so unglaublich kompliziert an.
Ich bin mir nur nicht sicher ob die lagerdeckel dann noch gehont werden müssen.
Ich hoffe dass mir einer von euch weiterhelfen kann.
MfG